Most Dangerous Intersections in Fort Lauderdale

27 February 2019

Driving in Fort Lauderdale can be pretty intimidating and for good reason. Broward County is repeatedly found to be one of the most dangerous places to drive in the country, with a total of 41,755 accidents reported in 2016, which resulted in 245 deaths and 25,361 injuries. There are a lot of reasons that this could be the case, but the intersections of Fort Lauderdale might play at least some role in these numbers. Who hasn’t been uncomfortable sitting at a massive intersection, paying attention to the left turn, right turn, and straight green or red lights trying to figure out when it’s safe to go? Fort Lauderdale’s Zero Vision movement is an effort to reduce injuries and fatalities across the city for drivers, pedestrians, cyclists, and everyone else who shares these roads.

Take a look at some of the most dangerous intersections, and tell us what intersections you think are worth mentioning in the comments below.

Contents

1 A1A and Las Olas Blvd
2 Sunrise Blvd and Andrew Avenue
3 NE 26th Street and Federal Highway
4 Not Just Concerning for Drivers

A1A and Las Olas Blvd

In 2015, this intersection had more than 1,000 accidents that caused injuries. That means that this doesn’t even include fender-benders where nobody was injured. Many accidents at this intersection are from one car rear-ending another, which can cause serious problems like whiplash. For personal injury firms like Friedland & Associates, this intersection is well-known due to the high number of injury cases that begin there.

Sunrise Blvd and Andrew Avenue

A lot of the accidents at this intersection comes from people either trying to race through yellow lights. When a driver decides to try to beat the light, they quickly realize how wide the intersection is, and may not be across completely before the other drivers begin to move through their now-green lights. For those who think that yellow means “speed up,” Florida’s intersections are a simple proof of why this is a bad idea.

NE 26th Street and Federal Highway

Depending on the side and direction of the street you are traveling on, this intersection has both 3- and 4-lane roads that either direct drivers to go straight, left, or right. This can often lead to confusion, especially for tourists who are unfamiliar with such large intersections or are just getting familiar with their rental vehicles as they cause an accident in one of the many lanes. Of course, we can’t pin all of the blame on tourists, so make sure you keep an eye out when you are coming through this intersection as well

Not Just Concerning for Drivers

Intersections can cause serious problems for drivers, but they can cause serious problems for pedestrians and cyclists as well. When traveling on foot, some intersections require pedestrians to cross eight full lanes of traffic before they are safe to the other side, which is just one reason that Broward County is so dangerous for pedestrians. Florida has the highest rate of pedestrian deaths in the country. In addition to foot traffic, cyclists must navigate these roads while sharing lanes with drivers who are either inexperienced with interacting with cyclists, or simply not expecting them on such busy streets.

Read Also:

Ariana Smith

I enjoy writing and I write quality guest posts on topics of my interest and passion. I have been doing this since my college days. My special interests are in health, fitness, food and following the latest trends in these areas. I am an editor at Content Rally.

View all posts

Does Equipment Rental Really Result in Savings?

Renting heavy equipment used in construction has seen a steady rise in the past several years. Many contractors, business owners, and project managers seem to prefer renting a variety of machinery used in various stages of construction. Perhaps the most obvious conclusion on why renting has become the go-to solution in recent years is that it is more convenient and relinquishes the renter from any obligations once the rental period is over. However, are there other, more compelling reasons for choosing to rent heavy equipment instead of buying?The primary objective of Crane Hire Lincoln and other plant hire companies is to provide an extensive range of services for various sectors that require different kinds of heavy equipment. Although it is clear that renting does appear to be an optimal solution, it is still essential to take a closer look at whether it is best for all situations. Why is renting worth it? Buying heavy machinery is a significant investment. Such equipment requires consistent maintenance and a dedicated storage area. Over some time, these pieces of equipment will eventually depreciate. If you conduct a cost-benefit analysis, buying equipment to use only several times before putting it in storage is not a cost-effective decision. Hence, renting appears to be the best choice in these scenarios. Renting equipment as a short-term solution Depending on what kind of heavy equipment you need, if you consider buying, you will spend thousands on every single machine. If you need multiple machines to complete a project, the overhead cost will be staggering. Renting equipment at reasonable prices according to how long you will need the equipment helps in minimizing the cost of project completion. The bottom line is, if you only need the equipment for a short time, renting is the best solution. Additional benefits of renting equipment Aside from saving money on the cost of equipment acquisition, there are other benefits to construction equipment rental:No need to worry about maintenance. Most equipment rental agreements will not require the customer to perform any maintenance on the machine. Before the equipment gets delivered to the job site, it is the responsibility of the rental company to ensure that the machine is in good working condition. Usually, after the rental period is over, the rental company also takes care of equipment removal and clean-up. No need to dedicate storage space. Large pieces of machinery require ample storage space. If you do not own space, you might need to secure a storage facility for your company’s equipment. Renting machinery relieves you of this concern. No need to invest in staff training. Some heavy machinery requires operators to secure a license and be adequately trained. If you buy equipment, you will also need to hire and train employees who will operate it. Rental companies usually provide an operator as part of the rental agreement, if required.In conclusion, equipment rental is a cost-effective solution for short-term equipment needs. Nevertheless, depending on the nature of your business and how often you need to use a particular piece of equipment, it is also worth considering buying if you have the need and the resources to do so.Read Also:Boat Rentals At Lake Champlain Which Mobile Router Rental You Should Choose In Italy?

How To Operate A High Lift Jack Safely And Effectively

High lift jacks have been in use for over a century now. It first hit the market in 1905, when Bloomfield Manufacturing Company introduced it as the Automatic Combination Tool. After the first launch, the jack has found many uses because of its simple design and sturdy layout.It is certainly not the safest product and does not involve any high-end technology, but it is still in extensive use and also one of the most copied designs in the automobile care industry. As far as safety is concerned, it is very capable of sending you to a hospital bed with a lot of work for the surgeon.Read also: Along For The Ride: Passenger Rights In Vehicle Accidents Jack of All Trades The high lift jack has one of the most straightforward designs among all tools of car care and maintenance. In its basic avatar, it is just a massive mechanical lever. This uncomplicated design is perhaps the reason for its multipurpose utility. Some of the common uses of the high lift jack are given below:Lift up the vehicle to change the tire. Its got plenty of power and speed to lift your 4-wheeler effortlessly. This is the most basic and mostly used the role of the jack. It can even lift up much higher for other uses. It can be used as a winch to get you out of trouble. I also use it for breaking the tire bead so that it can be cleaned. It is good to be used as a spreader or a clamp. You could turn the vehicle around on the spot by lifting one end of the vehicle and then pushing it to a side away from the jack.Read also: Will Self-Driving Cars Replace Human Error? How to Use?Being a high-risk tool, it is very important that you take all the precautions to get the best use from the high lift jack. Before you put the tool in operation, you should first understand how to use a high lift jack. Some critical points regarding the use of the jack for its main roles are mentioned below:- Lifting Up Steps to be followed are given below:Check the ground, level it if required, use a base plate if the ground is soft to avoid sinking and falling off. Switch the reversing latch at "up" after positioning the jack firmly. Put one hand on top of the jack to maintain balance, pull the handle to get the jack toe to touch the vehicle bumper. Check that the rack should be vertical and the jack on a firm base. Hold the handle and push it down to lift the vehicle. Follow the reverse with basic common sense to get the load down after the tire changing is done.Read also: How To Shop For A Car With Your Teen Driver? Getting UnstuckThe same procedure as above will be used to lift the vehicle and then stack some rocks etc under the wheels to provide for a stable base before removing the obstacle from under the vehicle. You might have to push the vehicle's lifted up portion to aside in order to rescue it from a difficult situation. Winching Operation When the need arises, use the jack as a winch with a shackle and a chain. It is a powerful but slow winch, so you have to be patient. Put a chain, wire rope or a recovery strap to join the jack's toe with the recovery point on the vehicle. Put another chain from the top of the rack to the anchor. Remove all slack in the chains and proceed by operating the jack in the same manner when you are lifting the vehicle up. Miscellaneous Uses The jack's capability to lift is not limited to cars, it can be used to lift any other item as well. The main operational precautions will remain the same as mentioned above. Some of its additional uses are:-It can become a great hoisting tool when used in conjunction with a couple of shackles. The top clamp of the jack makes it very good for use as a huge clamp as well as a spreader. Even a bent tie rod end can be straightened using this amazing tool.If you only know how to use a High lift jack and take basic precautions then this tool is the most amazing piece of engineering that you will ever encounter. However, if you ignore the safety precautions, you could land in a hospital bed very soon.Read also: How To Get An Auto Loan At A Low-Interest Rate Along For The Ride: Passenger Rights In Vehicle Accidents

5 Most Important Motorcycle Safety Tips All Riders Need to Know

Your helmet's off, your hair's blowing in the wind, and you're cruising down the highway with the sun setting in bright oranges and reds. Life is good, right?As good as life may be in the moment, you may be putting your life and others at risk through reckless driving and ignoring basic rules.Even if you mean well, it's important to know how to ride a motorcycle safely, so today we'll take a look at five critical motorcycle safety tips. 5 Most Important Motorcycle Safety Tips All Riders Need to Know According to the National Traffic Highway Safety Administration, motorcyclists are 27 times more likely to die in traffic accidents than any other vehicle.Being a single rider going upwards of 75 miles per hour in the fresh air leaves you open to so many dangers.Not only that, you're potentially putting the lives of other drivers and passengers at risk. In fact, if you've experienced the loss of a loved one through a motorcycle accident and don't know what to do, learn more here.But if you're going to be proactive and learn some motorcycle driving tips, let's get into some of the most important ones now. 1. Always Wear the Proper Gear: Never ever go for a ride on your motorcycle without safety gear. Please know that buying this is very easy as you can buy motocross gear from an online store with a single click. This will help you stay safe in the event you get into an unfortunate accident.You've heard it since you were five years old and learning to ride a bike with training wheels, and maybe you're sick of hearing it, but ALWAYS WEAR A HELMET.Riding a motorcycle without a helmet can certainly feel nice, but it is by far the most protective piece of equipment you can (and should) be wearing.Other important gear includes:Face shield Eyewear (even prescription glasses or sunglasses counts for something) Padded jackets Padded gloves Padded pants Riding bootsHeavy-duty riding boots are good for grip when using the clutch and keeping balance. The rest of the clothing protects you from the elements when you're out in the open and gives you that much more padding if you were to go flying. 2. Drive Carefully and Defensively: Motorcycles are fast compared to other vehicles. You're just a single person on a smaller, aerodynamic vehicle able to rip through traffic.Make sure to always obey all traffic rules, though, such as speed limits, yield signs, and more.It's especially important for you as a motorcyclist to drive defensively as it may be more difficult for people in larger, enclosed vehicles to see you. 3. Always Be Visible: Speaking of being seen, make sure to wear colors that make you stand out and to drive in a way that you're easily seen by other drivers.Avoid black and dark brown clothing and stick to brighter colors or use neon strips and tape.Avoid other driver's blindspots if you can. 4. Be Awake and Be Sober: This is true for anyone operating any kind of vehicle, but make sure you don't drive when you are tired or intoxicated.You may be focusing more on the sober aspect than the awake aspect, but it's crucial to only drive when you're fully awake and alert. Being sleepy can reduce your reaction time to obstacles and potential accidents. 5. Start Your Ride the Right Way: Every time you hop on your motorcycle, remember to follow procedures beforehand so that you can ride safely.In particular, do these every week:Check tire pressure Check for oil leaks Test your headlights, taillights, and signal lights Check all hydraulic and coolant fluid levelsAlso, do these every time you ride:Check that clutch and throttle are smooth and operational Adjust mirrors Test the firmness of your brakes Test that your horn worksThese are basic checks that shouldn't take you any time at all and could prevent massive amounts of damage, injury, and maybe even deaths. Seeking More Advice and Tips for Riding Safely Riding a motorcycle is thrilling, and if it's something you enjoy, you should certainly take advantage of the open road.But it's especially important to follow basic motorcycle safety tips since you are at much more risk than drivers in other vehicles.If you'd like to see more riding tips or more advice on vehicles in general, check out our other automotive blog posts!Read Also:Along For The Ride: Passenger Rights In-Vehicle Accidents How To Choose The Right Motorcycle Tires For The Motorcycle